Filter
Top Products
Total Access 600 Series User Manual © 2002, ADTRAN, Inc.
Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B
Page 70
Appendix G. RFC1483 Quick Start (Bridging)
The Total Access 600 allows for complete integration of voice and data delivery from one compact platform. Once
you have completed the voice turn up procedure from the previous example, adding data to the circuit requires some
additional setup.
To configure a Total Access 600 for Bridging, you need to know the VPI and VCI values for the data circuit on your
network.
Bridging
Step Action
1
From the Total Access 600 main menu, select the W
AN
menu. (Here
you set up the ATM network.)
2 Select the ATM C
ONFIG
menu.
3 Enter the I
DLE
C
ELLS
format for your network.
4 Set D
ATA SCRAMBLING
appropriately for your network.
5
Back all the way out to the top level Total Access 600 menu, and then
select the R
OUTER
menu.
6
Enter the C
ONFIGURATION
menu.
From this menu, you will set up addresses for your LAN and WAN.
For basic IP routing, use all the default values from the
G
LOBAL
menu.
7
From the E
THERNET
menu, enter the IP menu to enter your LAN
configuration.
8
Enter your LAN
IP
ADDRESS
and
S
UBNET
M
ASK
.
For this example, the IP
ADDRESS
is 192.168.1.2 and the S
UBNET
M
ASK
is 255.255.255.0. This is not required, but will allow Telnet configuration
and TFTP upgrades from the LAN.
9
Arrow back to the main R
OUTER
C
ONFIGURATION
menu, and select the
WAN
menu and then the
ATM
menu. (Here you will enter your data
PVC information.)
10
Create a new PVC by entering the menu. Enter your VPI and VCI
values.
11
Disable IP on the RFC1483 IP menu and enable Bridging on the
RFC1483 B
RIDGE
menu. (This enables the Total Access 600 as a
bridge.)
12
Arrow back to the top level Total Access 600 menu to activate your
changes.
All packets that come in on the Ethernet will be forwarded on the WAN.