Filter
Top Products
6 Issue 2, December 2004 61180403L1-5B
Figure 2. DIP Switches Detail
Software Provisioning
The FXS/DPO is provisioned by connecting a VT100
terminal or a computer running a terminal emulation
program to the craft interface
ADMIN port located on the
System Controller Unit (SCU) front panel. Connection
to the port is made via a RS-232, DB-9 cable with a
male connector.
Craft port settings are as follows:
• 9600 Baud
• No parity
• 8 Data bits
• 1 Stop bit
• No Flow Control
The provisioning options for the FXS/DPO access
module are described in the following tables:
• Table 5, FXS/DPO General Options on page 7
• Table 6, FXS/DPO Mode Options on page 8
• Table 7, FXS/DPO Tandem Options on page 9
Password and User ID
Password protection is a function of the SCU and is
factory disabled. If password authentication is enabled,
then the SCU will display the
Logon screen. A valid
User Name and Password are required to access the
menus.
The default User Name is “user”, and the default
Password is “password”. The User Name and Password
are not case sensitive.
Menu Navigation
To traverse through the menus, select the desired entry,
and press
ENTER. To work backward in the menu, press
the
ESC (escape) key.
The menu tree in Figure 3 on page 10 illustrates the
path to every provisioning, performance, and test access
point in the Total Access 1500 FXS/DPO menu
ON
12345678
SD08
C & K
ON
12345678
SD08
C & K
ON
12345678
SD08
C & K
ON
12345678
SD08
C & K
D3
MODE 1
MODE 2
GS
A
UTO_TERM
900
RTG
DTG
DPC
RX64
RX32
RX16
RX08
RX04
RX02
RX01
SD
TX64
TX32
TX16
TX08
TX04
TX02
TX01
IMM
REV
NB64
NB32
NB16
NB08
NB04
NB02
SW4SW3SW2SW1
WINK
NORM
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
D4
OFF
OFF
LS
OFF
600
OFF
OFF
Switches SW1 through SW4 are used to select/deselect a particular “State” vice the labeled switch nomenclature of on/off.