Filter
Top Products
Chapter 2 System Setup
19
2.6 First System Boot
After you have properly installed the CompactFlash memory card pre-
installed with Windows CE or even with specific application software ,
all you have to do is simply plug in the power and the system is ready
for the first boot.
Power up for the first time
Please follow the steps below to perform your first system boot :
1. Turn on the power switch. Meanwhile, the Power LED on the front
panel will light up.
2. The Windows CE operating system starts to boot from the Compact-
Flash memory.
3. Wait for a while for Windows CE to complete its fist startup.
Assign the Device Name
After you have successfully booted for the first time, you can now
assign a Device Name to your HMI-640S for network identification.
Follow the instructions below to assign the Device Name:
1. First Click Start/Settings/Control Panel/Communication Proper-
ties to access the Communication Properties page.
2. Select the Device Name tab on the properties page, and assign a
Device Name to your HMI-640S. The Device Name is what comes to
distinguishe your HMI-640S within the network environment.
3. Click Ok to accept the Device Name setting.
4. Reboot your system to make your Device Name effective on the
network.
After you have assigned a Device Name to your HMI-640S on the
network, you can proceed futher with other configurations or installa-
tion procedures if need be.