Filter
Top Products
71 Chapter 7
tems. Run SCSISelect if you need to change or view
current settings, or if you would like to run the SCSI
disk utilities.
SCSI Select Options Available Settings Default Settings
SCSI Bus Interface
Definitions:
Host Adapter SCSI ID 0-15 7
SCSI Parity Checking Enable, Disabled Enabled
Host Adapter SCSI Termination
LVD/SE Connectors Automatic Automatic
Enabled
Disabled
SE Connectors Automatic Automatic
Low On/High On
Low Off/High Off
Low Off/High On
Boot Device Options:
Boot SCSI ID 0-15 0
Boot LUN Number
1
0-7 0
SCSISelect Options Available Settings Default Setting
SCSI Device Configuration:
Sync Transfer Rate (MBytes/
sec)
320, 160, 80.0, 53.4,
40.0, 32.0, 26.8,20.0,
16.0, 13.4, 10.0
ASYN
320
Initiate Wide Negotiation Yes, No Yes (enabled)
Enable Disconnection Yes, No Yes (enabled)
Send Start Unit Command Yes, No Yes (enabled)
Enable Write Back Cache
2
N/C (No Change),
Yes, No
N/C (No Change)
BIOS Multiple LUN Support
2
Yes, No No (disabled)
Include in BIOS Scan
2
Yes, No Yes (enabled)
Advanced Configuration
Options:
Reset SCSI Bus at IC Initializa-
tion
Enabled, Disabled Enabled
Display <Ctrl><A> Messages
during BIOS Initialization
Enabled, Disabled Enabled
Extended BIOS Translation for
DOS Drives > 1 GByte
Enabled, Disabled Enabled
Verbose/Silent Mode Verbose, Silent Verbose
Host Adapter BIOS Enabled,
Disabled : Not Scan
Disabled : Scan bus
Enabled
Domain Validation
2
Enabled, Disabled Enabled