Filter
Top Products
Chapter 2: Installing the Scanner 30
If your PC has a 50-pin connector and your Arcus 1200 is the only external SCSI device to
be connected to your PC:
" Note: If your configuration also consists of internal SCSI devices and if your SCSI controller
does not disable termination automatically, do not forget to disable the termination of the host
adapter. Consult your computer documentation for more information.
1
Set the scanner to an unused SCSI ID number between 0 and 6.
For more information, see Choosing a SCSI ID Number.
2
Connect the larger 50-pin end of the SCSI cable to the connector at the rear of your PC. Use
the SCSI cable supplied with the scanner.
3
Snap the diamond shaped wire clips into the clip brackets to secure the connection.
4
Place the terminator on the 50-pin connector of the scanner.
5
Snap the diamond shaped wire clips into the clip brackets to secure the connection.
6
Connect the smaller 25-pin end of the SCSI cable to the connector of the scanner.
7
Tighten the connector screws to secure the connection.