AGFA 1200 Scanner User Manual


 
Chapter 2: Installing the Scanner 33
If you install the scanner between two other external SCSI devices
1
Set the scanner to an unused SCSI ID number between 0 and 6.
For more information, see Choosing a SCSI ID Number.
2
Disconnect the SCSI cable from one of these two SCSI devices.
3
Connect the free end of this SCSI cable to the scanner.
4
Connect the 50-pin end of the SCSI cable (the one supplied with your scanner) to the other
adjacent SCSI device.
5
Snap the diamond shaped wire clips into the clip brackets to secure the connection.
6
Connect the 25-pin end of the SCSI cable (the one supplied with your scanner) to the scanner.
7
Tighten the connector screws to secure the connection.
8
Make sure that the last device in the chain is terminated.
Caution
: In this configuration you are not allowed to put the terminator on the scanner.
In case of problems, consult Appendix A: Troubleshooting.
Testing the Scanner and the Connection
You are now ready to check if the scanner is operating properly and if the devices are correctly
connected to your PC.
Caution
: Check if the scanner is properly unlocked.
1
Connect the power cord to the scanner.