Filter
Top Products
18
6. Basic Operation
6.1 Power ON/OFF: The Display is in Standby mode
- Press Standby ( ) button on the remote control or on the
front panel to turn on the unit. The power indicator changes
from red to green.
- Press
Standby ( ) button on the remote control or on the
front
panel again to return the display to standby mode.
The
power indicator changes from green to red.
Note: For protecting your PDP product, the interval time
between turn on
the PDP product and shut down it
should be kept at least one minute.
6.2 Selection of Input Mode
- Press Source button on the remote control or on the front
panel. A menu of input signal sources shall appear.
Press ▲ or ▼ to select the signal source you desired and
press
OK / ► to confirm the selection. The signal sources
are displayed in the following sequence:
When select the input source, the screen will display the direction.
Source Select:
AV
S-Video
YPbPr 1
YPbPr 2
VGA
HDMI
AV
Searching
Fill All
AV
NTSC 60Hz/3.58 MHz
S-Video
Searching
S-Video
No Input
Power Off In
15 Minutes
!
When there is no signal from the selected source (see illustration), either change the
channel or press
Source button to change sources. If there is no signal on your
selected source for 15 minutes the television will power down.