Allied Telesis AT-AR300 Network Router User Manual


 
Software Release 2.3.1 29
Software Release 2.3.1
C613-10325-00 REV B
Internet Protocol (IP)
In conjunction with BGP-4, a number of new commands have been added to
the implementation of IP, and several commands have been modified.
The new commands are:
ADD IP ASPATHLIST
ADD IP COMMUNITYLIST
ADD IP ROUTEMAP
DELETE IP ASPATHLIST
DELETE IP COMMUNITYLIST
DELETE IP ROUTEMAP
SET IP AUTONOMOUS
SET IP ROUTEMAP
SHOW IP ASPATHLIST
SHOW IP COMMUNITYLIST
SHOW IP ROUTEMAP
The modified commands are:
ADD IP FILTER
DELETE IP FILTER
SET IP FILTER
SHOW IP FILTER
For more information, see the Internet Protocol (IP) chapter of your switch or
router’s Software Reference. The latest Software Reference can be downloaded
from the support site at www.alliedtelesyn.co.nz/documentation/
documentation.html
IP and Interface Counters
Software Release 2.3.1 allows you to reset all MIB counters to zero for a
specified interface, or for all interfaces, or to reset all or individual IP counters.
To reset counters based on interface, use the command:
RESET INTERFACE[={ifIndex|interface}] COUNTER
where:
ifIndex is a decimal value specifying the entry in the interface MIB.
interface is an interface name formed by concatenating an interface type
and number.
This command resets the MIB counters for the interfaces specified. If an
interface is not specified, all the MIB counters will be reset. For example, to
reset the eth0 interface MIB counters, use either of the following commands:
RESET INTERFACE=eth0 COUNTER
RESET INTERFACE=1 COUNTER