Allied Telesis AT-AR300 Network Router User Manual


 
30 Release Note
Software Release 2.3.1
C613-10325-00 REV B
To reset IP interfaces, use the command:
RESET IP COUNTER={ALL|ARP|EGP|ICMP|INTERFACE|IP|MULTICAST|
ROUTE|SNMP|UDP}
This command resets the specified group of IP counters to zero (0). The
COUNTER parameter specifies the group of counters to be reset. If ALL is
specified, all IP counters are reset. If ARP, EGP, ICMP, INTERFACE, IP,
MULTICAST, ROUTE, SNMP or UDP is specified then those counters,
respectively, are reset. For example, to reset the IP route counters to zero, use
the command:
RESET IP COUNTER=ROUTE
SNMP and ARP counters are now displayed with the SHOW IP COUNTER
command. RIP is no longer a valid option for the SHOW IP COUNTER
command; to display RIP counters, use the command:
SHOW IP RIP COUNTER
The new syntax for the SHOW IP COUNTER command is:
SHOW IP COUNTER[={ALL|ARP|EGP|ICMP|INTERFACE|IP|MULTICAST|
ROUTES|SNMP|UDP}]
This command displays all or selected parts of the IP MIB. If an option is not
specified, or ALL is specified, all the IP counters are displayed. The output
displayed with the option ARP is shown in Figure 7 on page 30, and Table 8 on
page 30. The output displayed with the option INTERFACE has changed, and
is shown in Figure 8 on page 31 and Table 9 on page 31. The output displayed
with the option SNMP is shown in Figure 9 on page 32 and Table 10 on
page 32.
Figure 7: Example output from the SHOW IP COUNTER=ARP command.
ARP counter
arpRxPkts ........................... 0 arpTxPkts ......................... 0
arpRxReqPkts ........................ 0 arpTxReqPkts ...................... 0
arpRxRespPkts ....................... 0 arpTxRespPkts ..................... 0
arpRxDiscPkts ....................... 0 arpTxDiscPkts ..................... 0
Table 8: Parameters displayed in the output of the SHOW IP COUNTER=ARP
command.
Parameter Meaning
arpRxPkts The number of ARP packets received.
arpRxReqPkts The number of ARP Request packets received.
arpRxRespPkts The number of ARP Response packets received.
arpRxDiscPkts The number of inbound ARP packets discarded.
arpTxPkts The number of ARP packets transmitted.
arpTxReqPkts The number of ARP Request packets transmitted.
arpTxRespPkts The number of ARP Response packets transmitted.
arpTxDiscPkts The number of outbound ARP packets discarded.