Filter
Top Products
AT-2911 Series Gigabit Ethernet Network Adapters Installation and User’s Guide
35
Installing the AT-2911 Series Adapter Card
The following instructions describe how to install an AT-2911 series
adapter in most systems. Refer to the manuals that were supplied with
your system for details about performing these tasks on your particular
system.
To install an AT-2911 series adapter, perform the following procedure:
1. Review “Reviewing Safety Precautions” on page 30. and “Pre-
Installation Checklist” on page 32.
Before installing the adapter, ensure the system power is OFF and
unplugged from the power outlet, and that proper electrical grounding
procedures have been followed.
Warning
High voltage inside the system presents a safety hazard. Make sure
the power is off before removing the cover.
2. Remove the system cover. See Figure 11.
Figure 11. Removing the PC Cover
3. Select any appropriate empty PCIe slot.
If you do not know how to identify an appropriate PCIe slot, refer to
your system documentation.