Allied Telesis AT-AR236E Network Router User Manual


 
Figure 8 (Static IP Connection Setup)
To complete the connection you must now click the apply button. The apply button will
temporarily save this connection. To make the change permanent you need to click on Save
Settings (at the side of the page). At the system commands page, click on Save All.
4.4.1.6 Classical IP over ATM (CLIP, defined in RFC1577) Connection Setup
The Classical IP over ATM (CLIP) support provides the ability to transmit IP packets over an ATM
network, CLIP support will encapsulate IP in an AAL5 packet data unit (PDU) frame using
RFC1577and it utilizes an ATM aware version of the ARP protocol (ATMARP. support only allows
for PVC support; it does not support SVC).
To configure the ADSL Router for a CLIP connection, click on Setup and then click on New
Connection. The default CLIP connection setup is displayed. At the Type field select CLIP and
the CLIP connection setup page is displayed; figure 9 illustrates a typical CLIP configuration.
Give your CLIP connection a unique name; the name must not have spaces and cannot begin
with numbers. In this case the unique name is called CLIP1. Select the VPI and VCI settings;
your DSL service provider or your ISP will supply these; in this case the DSL service provider is
using 0,101. Also select the quality of service (QOS); leave the default value if you are unsure or
the ISP did not provide this information. You can also enable Network Address Translation (NAT)
and the Firewall options. If you are unsure, leave these in the default mode.
- 16 -