Filter
Top Products
52
2.13 Reset System
The switch can be rebooted or factory defaulted via the following methods.
Click Reboot System menu to reboot the switch.
Click Reset System menu to reset the switch to its factory default settings.
¾ Reboot System –Reboot the system. All configuration settings will be retained. If you want to
keep all your configurations then select this option.
¾ Reset System – Reset all configurations (including the username, password and IP address; only
the MAC address will not be changed) to default settings before rebooting the system. Means
that any customized configurations will be lost and can not be recovered.
The GSS-24T2SFP web smart switch also provides an alternative to Reset System by using the Reset
button on the rear panel:
¾ While the system is running (the DIAG LED indicator is ON), pressing and holding the Reset
button (over 5 seconds) until the DIAG LED indicator begins flashing, at any time will
activate the Write Default procedure.
After this procedure is completed, the switch will be rebooted and initialized using the default settings
automatically.
The GSS-24T2SFP switch takes approximatly10 seconds to reboot. You need to login the system
again to enter the web management configuration.