Filter
Top Products
MULTITASKER
400-0374-005
17
7.3 SUMMARY OF COMMANDS
Card Commands
1) [VER] Display firmware revision
2) [C] Display card status
3) [CnS] Save card settings
4) [?] Display system cards
5) [?C] Display card information
6) [STA1] Enable auto feedback
7) [STA0] Disable auto feedback
8) [SIG] Input signal detect
9) [EQ] Display equalization value
10) [ + ] Increment
11) [ - ] Decrement
12) [EQ=] Set equalization value
13) [CLR] Reset card to defaults
14) […S] Save command configuration
15) [TEST] Test internal memory ICs
16) [FBD] Enable/disable feedback delay
17) [RSI] Reset Card IDs
18) [SIDn] Set all Card IDs
19) [SIDnCi] Set one Card ID
20) [SID+n] Set all Card IDs to an offset
21) [RSN] Display card slot number
22) [HELP] Display available commands
Group Commands
23) [WR] Group multiple cards
24) [RMC] Remove member(s) from group
25) [RMG] Delete group
26) [RD] Display group members
7.4 MENU MODE
Menu Mode commands allow virtually the same
functionality as programming commands. Unlike
the programming commands in the previous
sections, menu commands prompt the user to
select from a list of available options. The system
then responds based upon selections made by the
user.
7.4.1 MENU COMMAND DEFINITIONS
Refer to section 7.2 for details on card functions
and examples. Following is a cross-reference of
menu mode sections versus programming
commands.
MENU COMMAND
Control [CLR]
Setup
Equalization [EQ], [+], [-]
Status [VER], [C]
Help [HELP]