Filter
Top Products
MULTITASKER™
400-0197-005
21
21
42. [RAMP=x] MT110-103 ONLY
This command sets the ramp rate for 32 steps.
The settings range from 4 to 18 seconds, in
two-second intervals.
Command Format: [RAMP=xCnUi]
x = Rate in Seconds
4 = 0.13 seconds/step
6 = 0.19 seconds /step
8 = 0.25 seconds /step
10 = 0.31 seconds /step
12 = 0.38 seconds /step
14 = 0.44 seconds /step
16 = 0.50 seconds /step
18 = 0.56 seconds /step
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
There is an MT110-103 in slot 5. Send the
command [RAMP=16C5] to set the ramp rate to
16 seconds. After this is set, any ramping will
occur at a rate of 32 steps in 10 seconds, or
0.50 seconds per step. Confirm the setting by
sending the command [RAMPC5] and receiving
the feedback:
RAMP TIME = 16 SECONDS
43. [MUT0] MT110-103 ONLY
This command turns on the all the outputs
without changing the input port selected and
without changing any volume settings.
Command Format: [MUT0CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [MUT0C4] to enable the
outputs for the card in slot 4.
44. [MUT1] MT110-103 ONLY
This command turns off all the outputs without
changing the input port selected and without
changing any output volume settings.
Command Format: [MUT1CnUi]
Cn = Card ID (n = # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
Example:
Send the command [MUT1C4] to mute all the
outputs for the card in slot 4.
45. [MATmXy]
The matrix command allows the matrix switcher
to be setup for different matrix sizes. The
following tables show how the inputs and
outputs will be configured when the matrix is
changed. The input and output layouts are as
viewed from the front of the card.
Example:
In the 4x4 configuration, when Input 1 is
connected to Output 4, the entire channel, 1a
and 1b, will be switched to outputs 4a and 4b
respectively.
Command Format: [MATmXyCnUi]
m = number of inputs (m = 8, 4 or 2)
y = number of outputs (y = 8, 4 or 2)
Cn = Card ID (n = slot # from 1 to max slots)
Ui = Unit ID (i = # from 0 to 9)
8 x 8
INPUTS OUTPUTS
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8