Filter
Top Products
SWITCHERS
10
2. [# SW n1 n2 n3 n4 n5 n6] - Audio Switch
Input
# = Switch number (no. from 1 to 9; default is
0).
n1 = Audio input number (no. from 0 to 6).
n2 = Break Away code: (0 = On; 1 = OFF)
n3 = 1, audio key pressed
n4 = 0, Sync Delay. The MX2436RM Switcher
is equal to zero. It is not necessary for
the switch to delay.
n5 = Video Equalizer (Hexadecimal no. from 1
to F).
n6 = Audio Gain (Hexadecimal no. from 1 to F).
This is the main command of the audio input
switcher containing all the information needed
by the switcher to activate the audio sources
connected to the unit.
Example:
Sending the [8SW6012F8] command will
activate switcher module 8 and audio input
number 6 only (because the breakaway code is
0). The “1” will let the switcher know that the
audio key was pressed with and interval of 2 (1
second), video equalizer was set to a maximum
and a normal volume of 8. Zero (0) = OFF and
default is 8 for normal volume or video).
3. [#RF] - Factory Reset
# = Switch number (default is 0)
This command will replace all the previously
stored settings in the memory of the switcher
module, which is indicated by the factory default
setting. Note that previously stored settings will
be lost.
Example:
Sending the [8RF] command resets the
Switcher module with ID number eight to the
factory settings.
4. [#RO] - Operation Reset
# = Switch number (default is 0)
This command will reset the following:
• Audio and Video is set to input #1
• Auto Switch is set to the OFF position
• Beep is set to the ON position
The following will not be affected:
• Audio Volume
• Video Equalization
• Auto Rotate
• Sync Delay
Example:
Sending the [8RO] command resets the
Switcher module with ID number eight to the
Reset Mode.
5. [# SA n] - Audio Breakaway
# = Switch number (default is 0)
n = 1 (ON) Audio Breakaway, Audio Input
Video Input and switchers can be
activated separately.
n = 0 (OFF) In this mode the switchers are
activated simultaneously. For example, if
Video Input 2 is pressed, Audio Input 2 will
be automatically activated.
This command controls audio and video input
numbers that will be sent simultaneously or
separately allowing the control of Audio input
and the video input independently.
Example:
Sending the command [1SA1] will allow the
user to select independently Audio Input from
Video Input.
Sync Delay
The MX2436RM Switcher is equal to zero.
Therefore, it is not necessary for the switch to
delay.