Filter
Top Products
DESIGNER SOLUTIONS
400-0503-001
15
2. [CLR]
This command resets the UT250-101 to the last
saved configuration.
Command Format: [CLR]
Example:
Clear the UT250-101 by sending [CLR]. Any
commands that were sent to the UT250-101
using the [...S] option will be recalled using this
command.
3. [VER]
This command displays the model number,
firmware version, and unit ID.
Command Format: [VER]
Example:
Send the command [VER], and the UT250-101
will return feedback similar to the following:
[UT250-101 690-0268-001 U0]
UT250-101 = the model number
690-0268-001 = the firmware version
U0 = the unit ID
4. [ONmX]
This command turns on one or more outputs.
Command Format: [ONmX]
m = Output No. (m = 1 or 2)
X = Channel No. (X = A, B, or blank for both)
Example:
Turn on Output 1A by sending [ON1A] to the
UT250-101. Outputs 1B, 2A, and 2B are
unaffected.
Turn on Outputs 2A and 2B by sending [ON2] to
the UT250-101. Outputs 1A and 1B are
unaffected.
5. [ON]
This command turns on all outputs.
Command Format: [ON]
Example:
Send [ON] to the UT250-101 and all 4 outputs
(1A, 1B, 2A, and 2B) will be enabled.
6. [OFFmX]
This command turns off one or more outputs.
Command Format: [OFFmX]
m = Output No. (m = 1 or 2)
X = Channel No. (X = A, B, or blank for both)
Example:
Turn off Output 1A by sending [OFF1A]. Outputs
1B, 2A, and 2B are unaffected.
Turn off Outputs 2A and 2B by sending [OFF2].
Outputs 1A and 1B are unaffected.
7. [OFF]
This command turns off all outputs.
Command Format: [OFF]
Example:
Send [OFF] to the UT250-101 and all 4 outputs
(1A, 1B, 2A, and 2B) will be disabled.
8. [InOmX]
This command connects one input to one
output.
Command Format: [InOmX]
n = Input No. (m = # from 1 to 8)
m = Output No. (m = 1 or 2)
X = Channel No. (X = A, B, or blank for both)
Example:
Connect Input 7 to Outputs 1A and 1B and then
Input 6 to Output 2A by sending the commands
[I7O1] and [I6O2A]. The first command connects
Input 7 to both channels of Output 1. The
second command connects Input 6 to Output 2
Channel A only.