Filter
Top Products
BIOS Setup
AN9 32X 3-21
3.6 Power Management Setup
Phoenix – Award BIOS CMOS Setup Utility
Power Management Setup
ACPI Suspend Type S3(Suspend-To-RAM) Item Help
- USB Resume from S3 Disabled
Power Button Function Instant-Off
Wakeup by PME# of PCI Enabled
Wakeup by OnChip LAN Enabled
Wakeup by Alarm Disabled
X - Day (of Month) Alarm 0
X - Time (hh:mm:ss) Alarm 0: 0 : 0
Cool’n’Quiet Technology Auto
Power On Function Button Only
X - KB Power On Password Enter
X - Hot Key Power On Ctrl-F1
Restore on AC Power Loss Power Off
↓↑
→←
:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults
ACPI Suspend Type
This item selects the type of Suspend mode.
[S1(PowerOn-Suspend)]: Enables the Power On Suspend function.
[S3(Suspend-To-RAM)]: Enables the Suspend to RAM function.
- USB Resume from S3
When set to [Enabled], this item allows you to use a USB device to wake up a system that is in
the S3 (STR - Suspend To RAM) state. This item can be configured only if the item “ACPI
Suspend Type” is set to [S3(STR)].
Power Button Function
This item selects the method of powering off your system:
[Delay 4 Sec.]: Pushing the power button for more than 4 seconds will power off the system.
This will prevent the system from powering off in case you accidentally hit or pushed the power
button.
[Instant-Off]: Pressing and then releasing the power button at once will immediately power
off the system.
Wakeup by PME# of PCI
When set to [Enabled], access through the add-on PCI card can remotely wake up the system
that was in Soft-Off condition. The PCI card must support the wake up function.