Filter
Top Products
Chapter 1 General Information 11
1.7.3 Wall-mounting (optional)
An optional wall-mounting attachment is also available for mounting the
PPC at approximately 45° to a flat surface. Installation instructions fol-
low:
1. The wall-mounting attachment is comprised of three parts: one
back bracket, one support bracket, and one mounting bracket.
2. First attach the back bracket to the rear cover of the PPC-L106T,
securing it in place with four of the philips-head screws provided.
3. Using a flat-head screwdriver, attach the support bracket to the
back bracket using four of the flat-head screws provided, two on
either side of the support bracket. The sides of the support bracket
should overlap the sides of the back bracket, and the screws should
secure one bracket to the other through the existing holes drilled
into each bracket.
4. Mount the mounting bracket on the wall or other flat surface. The
support bracket slides vertically from the top into the mounting
bracket. It can then can be secured to the mounting bracket by
screwing one of the philips-head screws provided through the cor-
responding holes at the tops of the mounting bracket and the sup-
port bracket.
Figure 1.6: PPC-L106T wall mounting configuration