Filter
Top Products
Programming with the AD2089
26 AD2089 Operator’s Manual
After the word “done” appears, pressing any key will remove the word from the LED display.
CPU to Keyboard Transfer
1 Set the receiving keyboard and the CPU to the appropriate baud rates.
2 Initiate the 1024 CPU to keyboard transfer by pressing [999] [F2]. The LED display will show
the following message:
3 To proceed with the transfer, press ACK. To cancel the action press CLEAR. Pressing any
other key will generate a beep indicating an invalid keystroke. If ACK is selected, the LED
display will show the following message:
4 The number in the ENTER display indicates the percentage of macros successfully transferred
to the keyboard. The number starts at 0 and increases in increments of 10, up to 100 percent.
With the keyboard set to 9600 baud and connected directly to the CPU, the transfer will take up
to three minutes. With the keyboard set at 1200 baud and connected through a Port Expander
set at 4800 baud, the transfer will take up to 12 minutes. During the transfer, any keystroke will
generate a beep (invalid keystroke). When the transfer is complete (the number “100” appears
in the ENTER display), the ENTER display will then show the following
After the word “done” appears, pressing any key will remove the word from the LED display.
Deleting Macros
If a keyboard is moved from one location to another, it may be appropriate to delete all previously
programmed macros. To delete all macros, hold down the SITE and F2 keys while unplugging and
re-plugging the keyboard cable at the bottom of the unit.