Filter
Top Products
3.9.4 Connecting the SEG-M to a HubMax System (RS-232)
Connect the SEG-M to the eight-position pin rail S1 above the first module on the backplane. Make sure the components on the SEG-
M are facing away from the module. Use the two card guides to secure the SEG-M in place by snapping them into the holes on either
side and sliding the SEG-M into them.
3.9.5 Connecting the SEG-M to a Hub MiniMax System (RS-232)
Connect the SEG-M to the eight-position pin rail S1 on the left hand side of on the backplane. Make sure the components on the SEG-
M are facing away from the module. Use the two card guides to secure the SEG-M in place by snapping them into the holes on either
side and sliding the SEG-M into them.
Page 14 of 34 Document Number: 6066005, Rev 3.2
Note: No additional connections
are required between the
HubMax and the SEG-M.
Note: No additional connections are required between the Hub MiniMax and the SEG-M.