Filter
Top Products
Chapter 1 Hardware Installation 29
Step 10 Connect I/O, Continued
J4 Floppy J4 is a 34-pin dual-inline berg. Connect the cable from the floppy drive to J4, as
shown below. The onboard floppy controller cannot be used if a hard disk card
with a floppy controller is installed. Choose Standard Setup and Peripheral
Setup to configure the floppy controller.
The motherboard supports up to two 720 KB, 1.44 MB, or 2.88 MB 3½" drives
and 360 KB and 1.2 MB 5¼" drives. The connecting cable is a 34-pin ribbon
connector with two 34-pin edge connectors for attaching the floppy disk
drives. There is a small twist in the cable between the floppy connectors. The
last (end) connector should be connected to floppy drive A:.
Cont’d