Filter
Top Products
5
Connect Utility Power to the Enclosure
Display panel
located inside the
enclosure.
Local, state, federal and/or National Electric Code (NEC) regulations regarding location,
permits and electrical wiring must be adhered to.
The customer supplied utility power cable may be routed through the side, top or bottom of the
enclosure. Knockouts for this purpose are marked inside the enclosure.
1. Open the door of the enclosure.
2. Using the appropriate size utility power cable, wire the Euro
block located on the display panel. See diagrams.
Connect the ground wire prior to connecting any other wires.
Install and Connect the Battery
b
atter
y
heater outlet
The use of an APC battery is recommended.
Contact APC or your dealer for details.
The battery terminals must be toward the front of
the enclosure when the battery is installed.