Filter
Top Products
Page 6
3.0 Installation
Input cable connections
3.3 Input wiring procedure - continued
To remove a knock-out, strike in the area shown with a nail set tool and hammer. Grasp the
edge of the knock-out with pliers and twist until the knock-out is separated from the plate.
Caution: The edge of the knock-out may be sharp!
Example showing removal of ¾" knock-out
3.3.3 Remove all screws that secure the power distribution plate from the rear of the Isolation
Unit. Move the power distribution plate aside gently. Take care not the strain the wires
connected to the devices on the plate.