Filter
Top Products
2-4
2. Push the Battery Wire Connector (Figure 5) into the hole located at the left of
the Battery Pack. Ensure that the Battery Wire Connector is pushed into the hole
and securely connected by gently pulling on the wire to see if it is attached to the
connector.
Figure 5. Battery Wire Connection
3. Install the battery retaining bar.
4. Install the front Bezel (Figure 6), by aligning the four pins located on the
back-side of the Bezel to the holes at the left and right sides of the unit. Gently
push the front Bezel onto the unit.
Figure 6. Front Bezel Installation