Filter
Top Products
990-1007A, Revision 2 9/99 16
Specifications
SUDP4000I SUDP6000I SUDP8000I SUDP10000I
Acceptable input voltage 220/230/240V
+10%/-15% normal operation
±10% bypass operation
Input voltage (on-line operation) 220/230/240 VAC
230 volt output range 220/230/240 VAC
Nominal input frequency 50 or 60 Hz
Input protection Resettable circuit breaker
Frequency limits (on-line operation) 50 or 60 Hz, 8%
Bypass Transfer time 2 ms typical, 5 ms maximum
Maximum load, Total 4000 VA 6000 VA 8000 VA 10000 VA
On-battery output voltage 230 VAC
On-battery frequency 50 or 60 Hz, 0.1 Hz;
unless synchronized to utility during brownout.
On-battery waveshape Low-distortion sine wave
Overload protection (on-battery) Overcurrent and short-circuit protected, latching shutdown on overload
Overload protection (on-line) 25A 40A 50A 63A
Noise filter Normal and common mode EMI/RFI suppression,
100 kHz to 10 MHz
Battery type Spill proof, maintenance free, sealed lead-acid
Typical battery life 5 years, depending on number of discharge cycles
and ambient temperature
Typical recharge time 24 hours from total discharge
Operating temperature 0 to 40৽C (+32 to +104৽F)
Storage temperature -15 to +45৽C (+5 to +113৽F)
Operating and storage relative humidity
30% to 95%, not condensing
Operating elevation 0 to +3,000 m (0 to +10,000 ft.)
Storage elevation 0 to +15,000 m (0 to +50,000 ft.)
Electromagnetic Compatibility (EMC) EN50091-2
Electromagnetic Interference (EMI) EN55022 Class A
Electromagnetic Immunity IEC 801-2, 801-3, 801-4, 801-5, 1000-2-2
EN60555-1, -2, -3, EN61000-4-1, EN61000-4-11
Audible noise in dBA at 1 m (3 ft.) 45 dBA
Safety approvals GS licensed by VDE to EN50091-1-1 and EN60950
Size (W x H x D) 315 x 650 x 610 mm
Weight 128 kg 138 kg
Limited Warranty
American Power Conversion (APC) warrants its products to be free from defects in materials and workmanship for a period of two years from the date
of purchase. Its obligation under this warranty is limited to repairing or replacing, at its own sole option, any such defective products. To obtain
service under warranty you must obtain a Returned Material Authorization (RMA) number from customer support (see the Service section of the User’s
Manual). Products must be returned with transportation charges prepaid and must be accompanied by a brief description of the problem encountered
and proof of date and place of purchase. This warranty does not apply to equipment which has been damaged by accident, negligence, or
misapplication or has been altered or modified in any way. This warranty applies only to the original purchaser who must have properly registered the
product within 10 days of purchase.
EXCEPT AS PROVIDED HEREIN, AMERICAN POWER CONVERSION MAKES NO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. Some states do not permit limitation or exclusion of
implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not apply to the purchaser.
EXCEPT AS PROVIDED ABOVE, IN NO EVENT WILL APC BE LIABLE FOR DIRECT, INDIRECT, SPECIAL, INCIDENTAL, OR
CONSEQUENTIAL DAMAGES ARISING OUT OF THE USE OF THIS PRODUCT, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH
DAMAGE. Specifically, APC is not liable for any costs, such as lost profits or revenue, loss of equipment, loss of use of equipment, loss of software,
loss of data, costs of substitutes, claims by third parties, or otherwise.