Filter
Top Products
CHAPTER 3: INSTALLATION
10
Connecting Load Equipment
Plug all load equipment into PDU receptacles.
• For AP9621, SYTF2, SYTF2J, SURT005, and SURT006
models, the receptacles are divided into 4 groups; each
group is protected by a 15-amp circuit breaker. A colored
label identifies each circuit and its circuit breaker.
• For SUTF3, SYTF3 and SYTF3J models, the output is
divided into 4 groups. Each group is protected by a 20-amp
circuit breaker that contains one (1) receptacle.
• When connecting the equipment, distribute the loads
evenly on the four output circuits.
Turning On the Step-Down Transformer
1. Turn on the Step-Down Transformer by switching the rear
panel input circuit breaker
to the ON position.
For AP9621, SYTF2, SYTF2J, SURT005, and SURT006
models, a colored label identifies each circuit and its
circuit breaker.
2. Turn on all connected equipment.
Depending on your required output power,
one of the fans may not be turning
because the internal temperature of the
Step-Down Transformer is less than
100°F. If 100°F is reached, the redundant
fan will turn on.