Filter
Top Products
Displaying Stream Content
71
MAX-CSE/MAX-CSD10 Operation/Reference Guide
10. From the Stream section of the page, locate the Transport Protocol field and use the drop-down
arrow to select a desired protocol. For the purposes of these procedures, select UDP as the protocol.
An UDP protocol is typically used with higher-bandwidth streams and only requires the entry
of a single Target Port because both the video and audio are combined into a single media
stream. With this method, the Modero panel always utilizes an audio port value of two greater
than that used by the Target Port.
An RTP protocol is typically used both with lower-bandwidth streams and when user wants to
purposely separate the video and audio information into two distinct streams. With this
method, the Target Audio Port must be manually entered and cannot be the same value as the
Target Port used for video.
11. Enter the previously obtained IP Address of the target Modero panel (FIG. 41) into the Target
Address field.
12. Enter a numeric value into the Target Port field. This field corresponds to the port on the destination
device to which the outgoing video (audio/video) stream is being directed.
It is recommended that this value not currently be used by another port on the target device.
It is recommended that the following ports also not be used: 21, 22, 23, 80, 443, and 1319.
For the purposes of these procedures, we’ve chosen to use 5000 as the video Target Port.
13. If using RTP as a Transport Protocol, enter a value into the Target Audio Port field. This field
corresponds to the port on the destination device where the audio only portion of the stream is being
directed to. This value cannot match the value entered into the Target Port field above. If using
UDP as a Transport Protocol, this field becomes greyed-out and unused since the both the audio and
video content is being combined into a single stream.
For the purposes of these procedures, we are not required to enter a Target Audio Port value
because the A/V content is not begin streamed separately.
14. Click the Apply button to save the encoding profiles to the MAX-CSE.
If using RTP, both the Target Port and Target Audio Port must be different and
should use even numbers.