Filter
Top Products
UPS Network Management Card 2 User’s Guide46
Environmental Monitoring
Note: If you install a Dry Contact I/O Accessory, AP9810, at your Network Management
Card, the Environment tab displays two top menu bar options, Universal I/O and
Environment. Except where noted, the settings described in this chapter are available for
both options.
Overview Page
The Overview page lists the status of environmental monitoring devices associated with the AP9631
Network Management Card of the UPS.
Temperature and Humidity Page
Brief status
Click Temp & Humidity on the left navigation menu to display the name, alarm status, temperature, and
humidity (if supported) for each sensor.
Detailed status and configuration
Click the name of a sensor for detailed alarm status or to configure its values:
Identification and alarm status.
Heading Displayed Information
Temperature
and Humidity
Lists all sensors and, for each sensor, the alarm status, temperature currently recorded, and
humidity (if supported) currently recorded. For detailed status or to reconfigure a sensor's
parameters, click the sensor's name.
Input Contacts Lists each enabled input contact and its alarm status and current state (open or closed). For
detailed status of an enabled input contact or to reconfigure that contact's parameters, click
the name of the contact.
Note: To view or configure the parameters of a disabled contact, or to enable it, you must
access the interface page for that contact through Input Contacts on the left navigation
menu
Output Relay Lists the alarm status and the current state (open or closed) of the output relay of the
integrated Environmental Monitor. For detailed status of that output relay or to reconfigure
its parameters, click its name.
Recent
Environmental
Events
The Recent Environmental Events field lists, in reverse chronological order, the most
recent environmental events. To view the entire event log, click More Events at the lower
right.
Parameter Description
Name A name for this sensor. Maximum: 20 characters.
Location This physical location of the sensor. Maximum: 20 characters.