Filter
Top Products
Replacement Parts
WARNING: All safety instructions in the Safety sheet (990-2984) should be read,
understood, and followed prior to handling the system. Failure to do so could result in
equipment damage, serious injury, or death.
WARNING: Only trained persons familiar with the construction and operation of
the equipment, as well as the electrical and mechanical hazards involved, may install
and remove system components.
Note: A maximum of two SmartSlots can be used.
Part Part number
16 kW power module for 48, 96 and 160 kW 400 V
SYPM10K16H
10 kW power module for 100 kW 208V, High Efciency
SYPM10KF2
Battery module (four battery units)
SYBT9-B4
Battery unit
SYBTU2-PLP
SmartSlot relay I/O module (option)
AP9610
Modbus/Jbus interface Card (option)
AP9622
Network Management Card (option) Go to www.apc.com for a list of Network Management
Cards
Power distribution module Go to www.apc.com for a complete list of breaker
Replace a Power Management Card
A: Only the cards in these two locations can be replaced.
1. Loosen the two Phillips screws on the sides of the card and carefully pull it out of the enclosure.
2. Install the new card and secure it with the two screws.
Note: The Symmetra PX 100 kW has an embedded NMC. The SmartSlots do not support
an additional NMC.
26
Symmetra™ PX48, 96, and 160 kW 400 V 100 kW 208 V Operation
990–3015E-001