Filter
Top Products
Site Preparation: Basic Installation Procedure
10 InfraStruXure Site Planning, Installation, Start-Up
6. Connect the power source to the PDU.
A licensed electrician must connect the power source.
7. Connect user contact inputs and output relays to the user connection plate.
8. Install Shielding Troughs, Shielding Partitions, and Cable Ladders.
9. Install the Rack Automatic Transfer Switches (ATS), Rack Power Distribution Units, and other
InfraStruXure rack-mount devices.
10. Route and attach PDU power cables to each Rack ATS and/or Rack PDU.
11. Route and attach communication cables to the InfraStruXure Manager hub (or switch).
12. Start the system.
Only qualified, APC-trained personnel may perform a system start-up.
13. Configure the InfraStruXure Manager.
See page 13 for detailed instructions.
See page 17 for detailed instructions.
S
ee also
For instructions, see the manuals included with your Shielding Troughs,
Shielding Partitions, and Cable Ladders.
S
ee also
For instructions, see the manuals included with your Rack ATS, Rack PDU, or
other InfraStruXure rack-mount device.
See page 22 for detailed instructions.
See page 27 for detailed instructions.
See page 29 for detailed instructions.
S
ee also
For instructions, see the manual included with your InfraStruXure Manager.