Filter
Top Products
Product Specifications
Appendix C
42 Aruba AP 60/61 0500160
Installation Guide December 2005
RF Radiation Exposure Statement
This equipment complies with FCC RF radiation exposure limits set forth for fixed
indoor use only. This equipment should be installed and operated with a minimum
distance of 38.5 centimeters (15.2 inches) between the radiator and your body for
2.4 GHz and 5 Ghz operations. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Radio Frequency Interference Requirements
This device is restricted to indoor use due to its operation in the 5.15 to 5.25 GHz
frequency range. The FCC requires this product to be used indoors to reduce the
potential for harmful interference to co-channel Mobile Satellite systems. High
power radars are allocated as primary users of the 5.25 to 5.35 GHz and 5.65 to
5.85 GHz bands. These radar stations can cause interference with and/or damage
this device.
Canada
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the interference-causing equipment standard
entitled “Digital Apparatus,” ICES-003 of the Department of Communications.
Cet appareil numérique respecte les limites de bruits radioélectriques applicables
aux appareils numériques de Classe B prescrites dans la norme sur le matériel
brouilleur: “Appareils Numériques,” NMB-003 édictée par le ministère des
Communications.
The use of this device operating either partially or completely outdoors may
require the user to obtain a license for the system according to the Canadian
regulations. For further information, contact your local Industry Canada office.
RSS-210
This device, when operated in the 5150-5250 MHz frequency range, is only for
indoor use.
RSS-Gen
This device has been designed to operate with the antennas listed at Table 3-1 on
page 23, and having a maximum gain of 15.0dBi for 2.4GHz and 14.0dBi for
5GHz. Antennas not included in this list or having a gain greater than 15.0dBi for
2.4GHz and 14.0dBi for 5GHz are strictly prohibited for use with this device. The
required antenna impedance is 50 Ohms.
CAUTION: High power radars are allocated as primary users (meaning
they have priority) in the 5250-5350 MHz and 5650-5850
MHz frequency ranges, and these radars could cause
interference and/or damage to LE-LAN devices.