Filter
Top Products
40 Chapter 2
Set Supervisor/User Password
When this function is selected, the following message appears at the center of the screen to assist you in
creating a password.
Type the password, up to eight characters, and press <Enter>. The password typed now will clear any
previously entered password from CMOS memory. You will be asked to confirm the password. Type the
password again and press <Enter>. You may also press <Esc> to abort the selection.
To disable password, just press <Enter> when you are prompted to enter password. A message will confirm
the password being disabled. Once the password is disabled, the system will boot and you can enter BIOS
Setup freely.
Supervisor Password has higher priority than User Password. You can use Supervisor Password when
booting the system or entering BIOS Setup to modify all settings. Also you can use User Password when
booting the system or entering BIOS Setup but can not modify any setting if Supervisor Password is enabled
X
Frequency/Voltage Control
X
Integrated Peripherals Set User Password
F10: Save & Exit Setup
Change/Set/Disable Password
V02.54 (C) Copyright 1985-2004, American Megatrends, Inc.
Esc: Quit
KLIJ
: Select Item
X
Power Management Setup Save & Exit Setup
X
PnP/PCI Configuration Exit Without Saving
X
Advanced BIOS Features Load Optimized Defaults
X
Advanced Chipset Features Set Supervisor Password
Phoenix - AwardBIOS CMOS Setup Utility
X
Product Information
X
PC Health Status
X
Standard CMOS Features