Filter
Top Products
Chapter 2: Basic installationChapter 2: Basic installation
Chapter 2: Basic installationChapter 2: Basic installation
Chapter 2: Basic installation
2-22-2
2-22-2
2-2
2.1 Preparation
Basic components to installBasic components to install
Basic components to installBasic components to install
Basic components to install
You need to install the following components to the VENTO 7700 chassis
kit.
1. Motherboard
2. Power supply unit (PSU)
3. Hard disk drive (s)
4. 5.25-inch drive(s)
5. Floppy disk drive(s)
6. Expansion card(s)
ToolTool
ToolTool
Tool
You need a flat screw driver to remove the slot covers.
2.2 Removing the side panel
To remove the side panel:
1. Locate the two thumbscrews
on the rear panel.
2. Turn each thumbscrew
counterclockwise to release
the side panel from the
chassis.
The thumbscrews do not completely disengage from the side plate.