Filter
Top Products
Chapter 2: Basic installationChapter 2: Basic installation
Chapter 2: Basic installationChapter 2: Basic installation
Chapter 2: Basic installation
2-142-14
2-142-14
2-14
5. Carefully insert the floppy disk
drive into the bay, then push it
inward until it is completely
flushed into the chassis.
6. Make sure that the FDD screw
holes are aligned with the FDD
bay screw holes.
7. Press down the drive bay lock
to secure the floppy disk drive
to the chassis.
8. Connect an FDD signal cable
to the FDD connector at the
back of the drive then connect
the other end to the FDD
connector on the
motherboard.
Refer to the motherboard
user guide for the location
of the FDD connector.
9. Connect a 4-pin power plug from the power supply unit to the power
connector at the back of the drive.
8
9