Filter
Top Products
2-4
Chapter 2: BIOS information
Updating the BIOS using a bootable floppy disk
1. Boot from the floppy disk.
2. At the “A:\” prompt, type “C:\” and then press <Enter>.
3. At the “C:\” prompt, type “AWDFLASH/ BIOSFILENAME” and then <Enter>.
For example: “AWDFLASH/ aw0702.bin” The AWDFLASH screen appears.
4. Follow steps 5 to 7 in “2.1.2 Using the Award BIOS Flash Utility.”
2.1.3 CrashFree BIOS feature
The CrashFree BIOS feature allows you to boot the computer from a floppy disk
and update the BIOS in case the original BIOS fails or gets corrupted.
1. You must have a bootable floppy disk ready before updating the
BIOS.
2. The bootable floppy disk could be the one that you created
following the procedure in section 2.1.1, and should contain the
AWDFLASH.EXE utility.
3. If the BIOS fails (ROM data or codes are corrupted), a message
appears during POST to indicate the failure.
To update the BIOS:
1. Turn on the computer, and when prompted, place the bootable floppy disk to
the floppy drive.
2. Follow the BIOS update procedure in section “2.1.2 Using the Award BIOS
Flash Utility.”
To use the CrashFree BIOS feature on this motherboard, install a VGA
card into one of the expansion slots before rebooting the computer. On
motherboards with onboard VGA, such as the A7V8X-MX SE, you will
not see the screen display when the BIOS crashes even if you reboot
the computer.