Filter
Top Products
Chapter 2: Hardware setup
2-22
2.8 Connecting the cables
The chassis includes power and signal cables that you need to connect to
the motherboard and to the devices that you will install.
Most of the cables for the chassis kit are already connected upon
shipment. When installing system devices and connecting cables,
make sure that all cables are routed properly for better system stability
and performance. Refer to the picture below when arranging cables.
Refer to the motheboard user guide for detailed information on the
connectors.
1. Chassis fan
2. 8-pin 12V AUX power
3. 24-pin ATX power
4. Primary IDE
5. Secondary IDE
Standard cables connected to the motherboard
6. Tertiary IDE
7. Floppy disk drive
8. 20-pin system panel
9. Front USB connector
1
2
3
4
6
5
7
8
9