Filter
Top Products
34
IV. Hardware Setup
IV. Hardware Setup
AP 3000 Hardware Reference Guide
IDSEL 1=off
IDSEL 0=off
ON
IDSEL 1=on
IDSEL 0=on
ON
IDSEL 1=on
IDSEL 1=off
ON
ON
IDSEL 1=off
IDSEL 0=on
ON
IDSEL1 IDSEL0 Slot1 Slot3B Slot5B
off off Resv.
on on 15 11 3
on off 14 6 1
off on 13 5 0
The chassis provides an adjustable expansion card guide to help hold
expansion cards in their slots.
SCSI ID Dip Switches (Cont’)
• 4-13. Expansion Card Guide
Expansion Card Stabilizer
All SCSI devices must have a SCSI identification number that is not in
use by any other SCSI device. SCSI devices vary in how they set the ID
number. Refer to the product manual for any additional devices that
you may install for details on how to set its ID number.
NOTE
Securing
Expansion Card
Guide
The expansion card guide is
mounted by four screws on the
top and bottom edge of the chas-
sis. There are 18 knobs on the
stabilizer. Turn the knob over the
appropriate expansion card
counterclockwise to extend the
metal arm under each knob.
Keep turning until the arm is
firmly pressed against the expan-
sion card. Turn the knob clock-
wise to retract the metal arm.
Knob
Metal Arm