Asus asus pc Computer Hardware User Manual


 
2-18 Chapter 2: Basic installation
2.9 Installingaoppydiskdrive
The V-Series M2V890 Barebone system comes with one 3.25-inch drive
bay for a oppy disk drive.
To install a oppy disk drive:
1. Remove the front panel cover.
For instructions on how to remove the front panel cover, refer to page
2-3 of section “2.3 Removing the side cover and front panel assembly”.
2. Carefully insert the oppy disk drive into the oppy drive bay until the
screw holes align with the holes on the bay.
3. Secure the oppy disk drive with two screws on both sides.
4. Connect the oppy disk drive signal cable to the signal connector at
the back of the drive.
3
3
2
5. Connect the other end of the signal cable to the oppy disk drive
connector on the motherboard. See page 4-4 for the location of the
oppy disk drive connector.
6. Connect a 4-pin power cable from the power supply unit to the power
connector at the back of the oppy disk drive.
Floppy ribbon
cable
Power cable