Filter
Top Products
3-16
Chapter 3: Software support
3.4 Creating a RAID driver disk
A floppy disk with the RAID driver is required when installing Windows
®
2000/XP
operating system on a hard disk drive that is included in a RAID set. Use the
support CD that came with the motherboard package to create a RAID driver disk.
To use the support CD:
1. Boot your computer.
2. Press <Del> during POST to enter the BIOS setup utility.
3. Set the optical drive as the primary boot device.
4. Save changes and exit BIOS.
5. Insert the support CD into the optical drive.
6. Press the any key when the system prompts “Press any key to boot from the
optical drive”. The following menu appears:
1) Make SIS RAID Driver Disk
2) Format Floppy Disk
3) FreeDOS command prompt
Please choose 1 ~ 3:_
7. Press <1> to create a RAID driver disk.
8. Insert a formatted floppy disk into the floppy drive then press <Enter>.
9. Follow succeeding screen instructions to complete the process.
OR
1. Start Windows.
2. Place the motherboard support CD into the optical drive.
3. When the Drivers menu appears, click SIS RAID Controller Driver Disk to
create a SIS RAID driver disk.
4. Insert a floppy disk into the floppy disk drive.
5. Follow succeeding screen instructions to complete the process.
To install the RAID driver:
1. During the OS installation, the system prompts you to press the F6 key to
install third-party SCSI or RAID driver.
2. Press <F6> then insert the floppy disk with RAID driver into the floppy disk
drive.
3. Follow the succeeding screen instructions to complete the installation.
Write-protect the floppy disk to avoid computer virus infection.