Filter
Top Products
2-28 Chapter 2: Hardware information
8. Power connectors (24-pin EATXPWR, 8-pin EATX12V, 4-pin EZ_PLUG1)
These connectors are for ATX power supply plugs. The power supply plugs
are designed to t these connectors in only one orientation. Find the proper
orientation and push down rmly until the connectors completely t.
7. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
•
Make sure to connect the 8-pin ATX +12V power plug when installing two
CPUs.
• You can either use the 4-pin +12V power plug or 8-pin ATX +12V power
plug when installing only one CPU.
L1N64-SLI
WS
L1N64-SLI WS Chassis intrusion connector
CHASSIS
+5VSB_MB
Chassis Signal
GND
(Default)
L1N64-SLI
WS
L1N64-SLI WS ATX power connectors
EATXPWR
ATX12V
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
+12 Volts
-5 Volts
+5 Volts
+3 Volts
-12 Volts
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12 Volts
+3 Volts
+5 Volts
Ground
GND +12V
GND +12V
GND +12V
GND +12V
EZ_PLUG1
+5V
EZ_DET
GND
+12V
for CPU1 for CPU0