Filter
Top Products
ASUS P3V133 User’s Manual 37
11. Wake-On-LAN Connector (3-pin WOL_CON)
The WOL_CON connector powers up the system when a wake-up packet or
signal is received from the network through an optional PCI-L101 LAN card.
IMPORTANT: This feature requires that the Wake-On-LAN Power Up Con-
trol is set to Enabled (see Power Management Setup under BIOS SETUP) and
that your system has an ATX power supply with at least 720mA +5V standby
power.
P3V133 Wake on LAN Connector
+5 Volt Standby
(No Connection)
Ground
WOL_CON
R
P3V133
12. IrDA-Compliant Infrared Module Connector (5-pin IR)
This connector supports the optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support this
feature. You must also configure the setting through “UART2 Use Infrared” in
Chipset Features Setup to select whether UART2 is directed for use with COM2
or IrDA. Use the five pins as shown on the Back View and connect a ribbon cable
from the module to the motherboard according to the pin definitions.
Front View
+5V
IRTX
IRRX
FIRRX
GND
Back View
P3V133 Infrared Module Connector
For the infrared feature to be available,
you must connect the optional Infrared
(IrDA) module to the motherboard.
+5V
IRRX
IRTX
(NC)
GND
R
P3V133
3. HARDWARE SETUP
Connectors
3. H/W SETUP