Filter
Top Products
ASUS P3V4X User’s Manual90
7. APPENDIX
7. APPENDIX
S370 CPU Cards
Socket 370 CPU Voltage
1.50Volts
123
1.55Volts
123
1.60Volts
123
1.65Volts
123
1.75Volts
123
1.70Volts
123
1.80Volts
123
2.00Volts
123
2.05Volts
123
2.10Volts
123
2.20Volts
123
2.40Volts
123
2.30Volts
123
2.50Volts
123
JP1
JP2
JP3
JP4
JP5
JP1
JP2
JP3
JP4
JP5
1.90Volts
123
1.85Volts
123
1.95Volts
123
CPU Def.
(Default)
123
2.60Volts
123
JP6
123 123
Using Coppermine Processor
(Default)
JP6
Using Celeron Processor
For S370-133 CPU Card
7.1.2 Setting up the ASUS S370 Series CPU Cards
Setting the CPU voltage is not necessary for current socket 370 processors. If re-
quired, your socket 370 processor should have its voltage requirement printed on its
surface or documentation. If no voltage is indicated or you are not sure, use the
“CPU Def.” setting as shown below. Notice that JP6 should be set for the S370-133
CPU card to distinguish between Coppermine and Celeron processors. The S370-L
CPU card can distinguish these two types of CPU automatically.
7.1.1 Using the ASUS S370 Series CPU Cards
The general procedure for using the ASUS S370 Series CPU cards:
1. Check the voltage setting for your socket 370 processor using the jumpers on
the card if necessary. For current socket 370 processors, the default setting should
be used.
2. Install the socket 370 processor. Installation of socket 370 processors is exactly
like socket 7 processors. Lift the brown lever to 90° to install the processor and
lower the brown lever to lock the processor.
3. Install the CPU fan.
4. Insert the ASUS S370 Series CPU cards into Slot 1 on the motherboard. The two
fins on the sides of the ASUS S370 Series CPU cards must catch on the retention
mechanism so that it locks in place.
5. Connect the socket 370 processor’s fan connector to the motherboard.
WARNING! Exceeding your socket 370 processor’s required voltage can dam-
age your processor permanently! Make sure that the jumpers are as shown for
“CPU Def.” unless otherwise specified before powering on your motherboard.