Filter
Top Products
5-26
Chapter 5: Software support
Follow these steps to install the hard disks for RAID configuration.
1. Set the jumpers of each hard disk as Master/Slave.
2. Install the hard disks into the drive bays.
3. Connect the HDD cables. These connection options are available for
creating a RAID 0 or RAID 1 array:
a) Connect two Parallel ATA HDDs to PRI_RAID connector and one
Serial ATA HDD to either one of the two Serial ATA connectors,
using separate parallel ATA or serial ATA cables.
b) Connect one Serial ATA HDD to each Serial ATA connector, using
separate serial ATA cables.
4. Connect the power cable to the power connector on each drive.
5. Boot the system and enter the BIOS Setup Utility.
6. Go to the
Advanced menu in BIOS and set the appropriate IDE
configuration settings.
7. Save your changes and Exit Setup.
8. Proceed to section 5.4.2 for the next procedure.
5.4.1 Install the hard disks
The PDC20378 chipset supports Ultra ATA/133/100/66 hard disk drives.
For optimal performance, install identical drives of the same model and
capacity when creating a disk array.
• If you are creating a RAID 0 (striping) array for perfomance, use two
new drives.
• If you are creating a RAID 1 (mirroring) array for protection, you can use
two new drives or use an existing drive and a new drive (the new drive
must be of the same size or larger than the existing drive).