Filter
Top Products
1-8
Chapter 1: Product introduction
1.6.2 Installing the CPU
Follow these steps to install a CPU.
1. Locate the 478-pin ZIF socket on the motherboard.
Make sure that the socket lever is lifted up to 90°-100° angle; otherwise, the
CPU does not fit in completely.
2. Unlock the socket by pressing the
lever sideways, then lift it up to a 90°-
100° angle.
5. When the CPU is in place, push
down the socket lever to secure the
CPU. The lever clicks on the side tab
to indicate that it is locked.
3. Position the CPU above the socket
such that its marked corner matches
the base of the socket lever.
4. Carefully insert the CPU into the
socket until it fits in place.
The CPU fits only in one correct orientation. DO NOT force the CPU into the
socket to prevent bending the pins and damaging the CPU!
Gold Mark
90º~100º angle
Socket Lever