Filter
Top Products
1-14
Chapter 1: Product introduction
1.10 Expansion slots
The motherboard has three PCI slots and one Accelerated Graphics Port (AGP) slot.
To install and configure an expansion card:
1. Install an expansion card following the instructions that came with the chassis.
NOTE: The AGP slot supports only 1.5V AGP cards.
2. Turn on the system and change the necessary BIOS settings, if any. See
Chapter 2 for BIOS information.
3. Assign an IRQ to the card. Refer to the tables below.
4. Install the drivers and/or software applications for the expansion card
according to the card documentation.
1.9.1 Memory configurations
You may install any DDR DIMMs with 64MB, 128MB, 256MB, 512MB, and 1GB
densities into the DIMM sockets.
1. DDR DIMM sockets 2 and 3 share the same rows, so if you install a
double-sided DIMM into DIMM2 socket, you must leave DIMM3 socket
empty.
2. You may install single-sided DIMMs into DIMM2 and DIMM3 sockets at the
same time but neither one can be x16 DDR module.
3. Double-sided x16 DDR DIMMs are not supported on this motherboard.
Use only the following combinations to install DDR DIMMs. Otherwise, the
system may not boot up.
DDR DIMM1 DDR DIMM2 DDR DIMM3
(Rows 0&1) (Rows 2&3) (Rows 3&2)
SS/DS DS None
SS/DS SS SS
* SS - Single-sided DIMM
DS - Double-sided DIMM