Filter
Top Products
34
Chapter 2: Hardware information
12. Floppy disk drive connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After
connecting one end to the motherboard, connect the other end to the
floppy drive. (Pin 5 is removed to prevent incorrect insertion when using
ribbon cables with pin 5 plug).
P4S533-VM
®
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
P4S533-VM Floppy Disk Drive Connector
PIN 1
13. CPU and Chassis Fan Connectors (2x3-pin CHAFAN1, CPUFAN1)
The two fan connectors support cooling fans of 350mA (4.2 Watts) or a
total of 1A (12W) at +12V. Orient the fans so that the heat sink fins allow
air flow to go across the onboard heat sinks instead of the expansion
slots. The fan wiring and plug may vary depending on the fan
manufacturer. Connect the fan cable to the connector matching the black
wire to the ground pin.
Do not forget to connect the fan cables to the fan connectors. Lack of
sufficient air flow within the system may damage the motherboard
components. These are not jumpers! DO NOT place jumper caps on
the fan connectors!
P4S533-VM 12-Volt Cooling Fan Power
CPUFAN1
GND
Rotation
+12V
CHAFAN1
GND
Rotation
+12V
P4S533-VM
®