Filter
Top Products
1-321-32
1-321-32
1-32
Chapter 1: Product introductionChapter 1: Product introduction
Chapter 1: Product introductionChapter 1: Product introduction
Chapter 1: Product introduction
P5GD1-VM
®
P5GD1-VM Chassis intrusion connector
CHASSIS
1
(Default)
+5VSB_MB
Chassis Signal
GND
P5GD1-VM
®
P5GD1-VM Speaker out connector
SPEAKER
1
+5V
1
GND
Speak Out
GND
10.10.
10.10.
10.
Chassis intrusion connector (4-1 pin CHASSIS1)Chassis intrusion connector (4-1 pin CHASSIS1)
Chassis intrusion connector (4-1 pin CHASSIS1)Chassis intrusion connector (4-1 pin CHASSIS1)
Chassis intrusion connector (4-1 pin CHASSIS1)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
11.11.
11.11.
11.
Speaker Out connector (4-pin SPEAKER1)Speaker Out connector (4-pin SPEAKER1)
Speaker Out connector (4-pin SPEAKER1)Speaker Out connector (4-pin SPEAKER1)
Speaker Out connector (4-pin SPEAKER1)
This connector connects to the case-mounted speaker and allows you
to hear system beeps and warnings.