Filter
Top Products
2-262-26
2-262-26
2-26
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware information
4.4.
4.4.
4.
Serial ATA connectors (7-pin SATA1 [red], SATA2 [red],Serial ATA connectors (7-pin SATA1 [red], SATA2 [red],
Serial ATA connectors (7-pin SATA1 [red], SATA2 [red],Serial ATA connectors (7-pin SATA1 [red], SATA2 [red],
Serial ATA connectors (7-pin SATA1 [red], SATA2 [red],
SATA3 [black], SATA4 [black])SATA3 [black], SATA4 [black])
SATA3 [black], SATA4 [black])SATA3 [black], SATA4 [black])
SATA3 [black], SATA4 [black])
These connectors are for the Serial ATA signal cables for Serial ATA
hard disk drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0,
RAID 1, RAID 5, or RAID 10 configuration with the Intel
®
Matrix
Storage Technology through the onboard Intel
®
ICH7R RAID controller.
Refer to Chapter 5 for details on how to set up Serial ATA RAID
configurations.
3.3.
3.3.
3.
ICH7R Primary IDE connector (40-1 pin PRI_IDE)ICH7R Primary IDE connector (40-1 pin PRI_IDE)
ICH7R Primary IDE connector (40-1 pin PRI_IDE)ICH7R Primary IDE connector (40-1 pin PRI_IDE)
ICH7R Primary IDE connector (40-1 pin PRI_IDE)
This connector is for an Ultra DMA 100/66 signal cable. The Ultra
DMA 100/66 signal cable has three connectors: a blue connector for
the primary IDE connector on the motherboard, a black connector for
an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive),
and a gray connector for an Ultra DMA 100/66 IDE master device (hard
disk drive). If you install two hard disk drives, you must configure the
second drive as a slave device by setting its jumper accordingly. Refer
to the hard disk documentation for the jumper settings.
• Pin 20 on the IDE connector is removed to match the covered hole
on the Ultra DMA cable connector. This prevents incorrect insertion
when you connect the IDE cable.
• Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.
P5LD2
®
P5LD2 IDE connector
NOTE: Orient the red markings
(usually zigzag) on the IDE
ribbon cable to PIN 1.
PRI_IDE
PIN 1