Filter
Top Products
2-262-26
2-262-26
2-26
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware information
3.3.
3.3.
3.
Serial ATA connectors (7-pin SATA1, SATA2, SATA3,Serial ATA connectors (7-pin SATA1, SATA2, SATA3,
Serial ATA connectors (7-pin SATA1, SATA2, SATA3,Serial ATA connectors (7-pin SATA1, SATA2, SATA3,
Serial ATA connectors (7-pin SATA1, SATA2, SATA3,
SATA4)SATA4)
SATA4)SATA4)
SATA4)
These connectors are for the Serial ATA signal cables for Serial ATA
hard disk drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0,
RAID 1, RAID 0+1, and JBOD configuration using the ULI
®
RAID
controller. Refer to Chapter 5 for details on how to set up Serial ATA
RAID configurations.
Enable the Serial ATA Controller item in the BIOS if you want to use the
Serial ATA RAID feature. See the
SouthBridge ConfigurationSouthBridge Configuration
SouthBridge ConfigurationSouthBridge Configuration
SouthBridge Configuration for
details.
P5RD1-V
®
P5RD1-V SATA connectors
SATA1
GND
RSATA_TXP1
RSATA_TXN1
GND
RSATA_RXP1
RSATA_RXN1
GND
SATA4
GND
RSATA_TXP4
RSATA_TXN4
GND
RSATA_RXP4
RSATA_RXN4
GND
SATA3
GND
RSATA_TXP3
RSATA_TXN3
GND
RSATA_RXP3
RSATA_RXN3
GND
SATA2
GND
RSATA_TXP2
RSATA_TXN2
GND
RSATA_RXP2
RSATA_RXN2
GND
• Due to chipset limitation, you cannot configure a RAID 0 set or JBOD
with more than two hard disk drives.
• Install the Windows
®
2000 Service Pack 4 or the Windows
®
XP
Service Pack1 or later when using Serial ATA.