Filter
Top Products
2-14 Chapter 2: BIOS setup
2.4.3 Onboard Devices Configuration
Configure ITE8712 Super IO Chipset
Serial Port1 Address [3F8/IRQ4]
Serial Port1 Mode [Normal]
Onboard 1394 Controller [Enabled]
Allows BIOS to enable
or disable the floppy
controller.
Serial Port1 Address [3F8/IRQ4]
Allows you to select the Serial Port1 base address.
Configuration options: [Disabled] [3F8/IRQ4] [3E8/IRQ4] [2E8/IRQ3]
Serial Port1 Mode [Normal]
Allows you to select the Serial Port1 mode.
Configuration options: [Normal] [IrDA] [ASK IR]
COMA Duplex Mode [Half Duplex]
Allows the BIOS to select Full or Half Duplex for Serial Port. This appears only
when the Serial Port1 Mode item is set to [IrDA] or [ASK IR] Configuration
options: [Full Duplex] [Half Duplex]
Onboard 1394 Controller [Enabled]
Allows you to enable or disable the onboard IEEE 1394a controller.
Configuration options: [Disabled] [Enabled]